MIL-DTL-45952A
TABLE II. Classification of Defects.
Inspection
Category
Defect
Method
Critical
None defined
Major
101
Material, not as specified (3.2)
Visual
102
Grip length, not as specified (3.5)
*SIE
103
Shank diameter, not as specified (3.5)
SIE
104
Shank straightness, not as specified (3.5.1)
SIE
Minor
201
Protective finish, missing or incomplete (3.4)
Visual
202
Other dimensions, not as specified (3.5)
SIE
203
Surface roughness, not as specified (3.5.2)
SIE
204
Workmanship (3.6)
Visual
205
Marking (3.8)
Visual
*SIE - Standard Inspection Equipment
4.5 Tests.
4.5.1 Double-shear. Samples taken as specified in 4.3.2 shall be subjected to a double-shear
test to determine conformance with 3.3.2. The test shall be conducted in accordance with
NASM1312-13.
4.5.2 Insertion and removal force. Samples taken as specified in 4.3.2 shall be subjected to an
insertion and removal force test to determine conformance with 3.5.3. Pins shall be inserted and
removed 15 times using the correct size holes specified in MIL-P-45952/1. Maximum and minimum
forces shall be within the limits specified. The ring shall not break or deform (see 3.5.4).
4.5.3 Protective finish. Tests of protective finishes shall be in accordance with the applicable
specification of 3.4.
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in
the contract or order (see 6.2). When packaging of materiel is to be performed by DoD or in-
house contractor personnel, these personnel need to contact the responsible packaging activity
to ascertain packaging requirements. Packaging requirements are maintained by the Inventory
Control Point's packaging activities within the Military Service or Defense Agency, or within the
military service's system commands. Packaging data retrieval is available from the managing
Military Department's or Defense Agency's automated packaging files, CD-ROM products, or by
contacting the responsible packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is
not mandatory.)
6.1 Intended use. Detent quick-release pins are intended for use for fastening where quick
assembly and disassembly are required. These pins can be inserted and removed by hand. They
should be used for shear applications only.
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business